R3102-R3103-HP 6600/HSR6600 Routers MPLS Configuration Guide

145
Outgoing Tunnel ID : 0x0
Label Operation : POP
No : 4
VrfIndex :
Fec : 3.3.3.3/32
Nexthop : 10.0.0.2
In-Label : NULL
Out-Label : 3
In-Interface : ----------
Out-Interface : POS5/1/1
LspIndex : 10242
Tunnel ID : 0x22000
LsrType : Ingress
Outgoing Tunnel ID : 0x0
Label Operation : PUSH
# Execute the display interface tunnel command on PE 1. The output shows that traffic is forwarded
along the CR-LSP of the TE tunnel.
[PE1] display interface tunnel 1
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 1500
Internet Address is 12.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 3.3.3.3
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 5 bytes/sec, 0 packets/sec
Last 300 seconds output: 5 bytes/sec, 0 packets/sec
34 packets input, 2856 bytes
0 input error
34 packets output, 2856 bytes
0 output error
Troubleshooting MPLS TE
No TE LSA generated
Symptom
OSPF TE is configured but no TE LSAs can be generated to describe MPLS TE attributes.
Analysis
For TE LSAs to be generated, at least one OSPF neighbor must reach the FULL state.