R3102-R3103-HP 6600/HSR6600 Routers MPLS Configuration Guide

31
Clearing MPLS statistics
Task Command Remarks
Clear MPLS statistics for one or all
MPLS interfaces.
reset mpls statistics interface
{ interface-type interface-number |
all }
Available in user view.
Clear MPLS statistics for all LSPs or
the LSP with a specific index or
name.
reset mpls statistics lsp { index | all
| name lsp-name }
Available in user view.
Clear statistics for all LSPs or the
LSP with a specific incoming label.
reset mpls statistics lsp [ in-label
in-label ]
Available in user view.
Clear statistics for all public
network tunnels or the one with a
specific LSP token.
reset mpls statistics tunnel [ token
token ]
Available in user view.
MPLS configuration examples
Configuring static LSPs
Network requirements
Router A, Router B, and Router C support MPLS.
Establish static LSPs between Router A and Router C so that subnets 11.1.1.0 / 24 a n d 21.1.1.0 / 24 c a n
access each other over MPLS. Test the connectivity of the static LSPs.
Figure 13 Network diagram
Configuration considerations
• On an LSP, the outgoing label of an upstream LSR must be identical with the incoming label of its
downstream LSR.
• Configure an LSP for each direction on the forwarding path.
• Configure a static route to the destination address of the LSP on each ingress node. Such a route is
not required on the transit and egress nodes. You do not need to configure any routing protocol on
the routers.