R3102-R3103-HP 6600/HSR6600 Routers MPLS Configuration Guide

419
# Configure PE 1.
[PE1] tunnel-policy gre1
[PE1-tunnel-policy-gre1] tunnel select-seq gre load-balance-number 1
[PE1-tunnel-policy-gre1] quit
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 100:1 both
[PE1-vpn-instance-vpn1] tnl-policy gre1
[PE1-vpn-instance-vpn1] quit
[PE1] interface gigabitethernet 2/1/1
[PE1-GigabitEthernet2/1/1] ip binding vpn-instance vpn1
[PE1-GigabitEthernet2/1/1] ipv6 address 2001:1::2 96
[PE1-GigabitEthernet2/1/1] quit
# Configure PE 2.
[PE2] tunnel-policy gre1
[PE2-tunnel-policy-gre1] tunnel select-seq gre load-balance-number 1
[PE2-tunnel-policy-gre1] quit
[PE2] ip vpn-instance vpn1
[PE2-vpn-instance-vpn1] route-distinguisher 100:2
[PE2-vpn-instance-vpn1] vpn-target 100:1 both
[PE2-vpn-instance-vpn1] tnl-policy gre1
[PE2-vpn-instance-vpn1] quit
[PE2] interface gigabitethernet 2/1/1
[PE2-GigabitEthernet2/1/1] ip binding vpn-instance vpn1
[PE2-GigabitEthernet2/1/1] ipv6 address 2001:2::2 96
[PE2-GigabitEthernet2/1/1] quit
# Configure CE 1.
<CE1> system-view
[CE1] interface gigabitethernet 2/1/1
[CE1-GigabitEthernet2/1/1] ipv6 address 2001:1::1 24
[CE1-GigabitEthernet2/1/1] quit
# Configure CE 2.
<CE2> system-view
[CE2] interface gigabitethernet 2/1/1
[CE2-GigabitEthernet2/1/1] ipv6 address 2001:2::1 24
[CE2-GigabitEthernet2/1/1] quit
After completing the configurations, execute the display ip vpn-instance command on the PEs to
view information about the VPN instance. Use the ping command to test connectivity between the
PEs and their attached CEs. The PEs can ping their attached CEs. Take PE 1 as an example:
[PE1] display ip vpn-instance
Total VPN-Instances configured : 1
VPN-Instance Name RD Create Time
vpn1 100:1 2006/08/13 09:32:45
[PE1] ping ipv6 -vpn-instance vpn1 2001:1::1
PING 2001:1::1 : 56 data bytes, press CTRL_C to break
Reply from 2001:1::1
bytes=56 Sequence=1 hop limit=64 time = 1 ms
Reply from 2001:1::1