R3102-R3103-HP 6600/HSR6600 Routers Security Configuration Guide

373
Figure 140 Adding a Web proxy server resource
3. Configure the Web proxy server resource as described in Table 17.
Table 17 Configuration items
Item Descri
p
tion
Resource Name
Enter a name for the Web proxy server source.
The resource name must be unique in the SSL VPN system. Resources are
uniquely identified by their names.
Website Address
Specify the Website address for providing Web services. It must start with http://
and end with /, for example, http://www.domain.com/web1/.
The website address can be an IP address or a domain name. If you specify a
domain name, make sure that you configure domain name resolution at the CLI.
For information about the CLI configuration for IPv4 domain name resolution, see
Layer 3—IP Services Configuration Guide.
Default Page
Specify the home page to be displayed after an SSL VPN user logs in. For
example, index.htm.
Website Matching Mode
Specify website matching patterns to determine which webpages a user can
access through the website specified in the Website Address field.
Website matching supports fuzzy match based on wildcard *. Use vertical bars
(|) to separate multiple matching patterns.
Assume that you have specified a website address in the Website Address field.
To allow access to specific webpages provided at the website, for example, the
webpages www.domain1.com, www.domain2.com, www.domain2.org, and
www.domain2.edu, you can specify www.domain1.com|www.domain2.* as
the matching patterns.
Enable page protection
Select this box to enable page protection.
With page protection enabled, a login user cannot capture screen shots, save
pages, or printing pages.
4. Set whether to enable single login:
To enable single login, select the box before the Single login field to expand the configuration area
(as shown in Figure 141), and then conf
igure the single login parameters as described in Table
18.