R3303-HP 6600/HSR6600 Routers Interface Configuration Guide

49
Ste
p
Command Remarks
3. Set the interface description.
description text
Optional.
By default, the description of a
POS interface is interface name
Interface, for example, POS1/2/0
Interface.
4. Set the clock mode.
clock { master | slave }
Optional.
The default is slave.
5. Set the CRC length.
crc { 16 | 32 }
Optional.
The default is 32 bits.
6. Set the loopback mode.
loopback { local | remote }
Optional.
Loopback is disabled by default.
7. Configure the overhead bytes.
• flag c2 flag-value
• flag { j0 | j1 } { sdh | sonet }
flag-value
Optional.
By default:
• The C2 overhead byte is
hexadecimal 16.
• SDH framing applies. In SDH
framing, both J0 and J1
overhead bytes are null. In
SONET framing, the J0
overhead byte is 0x01 and J1
overhead byte is null.
8. Ignore CRC of the J1 byte.
flag j1 ignore
Optional.
By default, CRC is performed for
the J1 byte.
9. Set the framing format.
frame-format { sdh | sonet }
Optional.
The default is SDH.
10. Configure scrambling.
scramble
Optional.
Scrambling is enabled by default.
11. Set the link layer protocol.
link-protocol { fr [ ietf | mfr
interface-number | nonstandard ]
| hdlc | ppp }
Optional.
The default is PPP.
12. Set the interface MTU.
mtu size
Optional.
The default MTU is 1500.
13. Set the signal degrade (SD) or
signal fail (SF) alarm threshold
for the interface.
threshold { sd | sf } value
Optional.
By default, the SD alarm threshold
is 10e-6 (the value argument is 6),
and the SF alarm threshold is
10e-3 (the value argument is 3).
14. Set the physical state change
suppression interval on the
interface.
link-delay seconds
Optional.
By default, physical state change
suppression is disabled on the
interface.
15. Set the intended bandwidth
for the POS interface.
bandwidth bandwidth-value Optional.