R3303-HP 6600/HSR6600 Routers IP Multicast Command Reference

16
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 225.1.1.1 0
[Sysname-acl-basic-2000] quit
[Sysname] interface gigabitethernet 2/0/1
[Sysname-gigabitethernet2/0/1] igmp-snooping group-policy 2000 vlan 2
Related commands
group-policy
igmp-snooping host-aging-time
Use igmp-snooping host-aging-time to set the aging timer for the dynamic member ports in the current
VLAN.
Use undo igmp-snooping host-aging-time to restore the default.
Syntax
igmp-snooping host-aging-time interval
undo igmp-snooping host-aging-time
Default
The aging timer of the dynamic member ports is 260 seconds.
Views
VLAN view
Default command level
2: System level
Parameters
interval: Sets an aging time for the dynamic member port in seconds, in the range of 200 to 1000.
Usage guidelines
This command takes effect only if IGMP snooping is enabled in the VLAN.
Examples
# Enable IGMP snooping for VLAN 2 and set the aging timer for the dynamic member ports in the VLAN
to 300 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping host-aging-time 300
Related commands
• host-aging-time
• igmp-snooping enable