R3303-HP 6600/HSR6600 Routers IP Multicast Configuration Guide

279
# On Router C, specify the tunnel encapsulation mode as GRE over IPv6 and assign the source and
destination addresses to interface Tunnel 0.
[RouterC-Tunnel0] tunnel-protocol gre
[RouterC-Tunnel0] source 3001::2
[RouterC-Tunnel0] destination 2001::1
[RouterC-Tunnel0] quit
3. Configure OSPFv3:
# Configure OSPFv3 on Router A.
[RouterA] ospfv3 1
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
[RouterA] interface gigabitethernet 2/1/1
[RouterA-Gigabitethernet2/1/1] ospfv3 1 area 0
[RouterA-Gigabitethernet2/1/1] quit
[RouterA] interface gigabitethernet 2/1/2
[RouterA-Gigabitethernet2/1/2] ospfv3 1 area 0
[RouterA-Gigabitethernet2/1/2] quit
[RouterA] interface tunnel 0
[RouterA-Tunnel0] ospfv3 1 area 0
[RouterA-Tunnel0] quit
# Configure OSPFv3 on Router B.
<RouterB> system-view
[RouterB] ospfv3 1
[RouterB-ospfv3-1] router-id 2.2.2.2
[RouterB-ospfv3-1] quit
[RouterB] interface gigabitethernet 2/1/1
[RouterB-Gigabitethernet2/1/1] ospfv3 1 area 0
[RouterB-Gigabitethernet2/1/1] quit
[RouterB] interface gigabitethernet 2/1/2
[RouterB-Gigabitethernet2/1/2] ospfv3 1 area 0
[RouterB-Gigabitethernet2/1/2] quit
# Configure OSPFv3 on Router C.
[RouterC] ospfv3 1
[RouterC-ospfv3-1] router-id 3.3.3.3
[RouterC-ospfv3-1] quit
[RouterC] interface gigabitethernet 2/1/1
[RouterC-Gigabitethernet2/1/1] ospfv3 1 area 0
[RouterC-Gigabitethernet2/1/1] quit
[RouterC] interface gigabitethernet 2/1/2
[RouterC-Gigabitethernet2/1/2] ospfv3 1 area 0
[RouterC-Gigabitethernet2/1/2] quit
[RouterC] interface tunnel 0
[RouterC-Tunnel0] ospfv3 1 area 0
[RouterC-Tunnel0] quit
4. Enable IPv6 multicast routing, IPv6 PIM-DM, and MLD:
# On Router A, enable IPv6 multicast routing globally, and enable IPv6 PIM-DM on each interface.
[RouterA] multicast ipv6 routing-enable