R3303-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Command Reference

143
• garp timer leaveall
garp timer leaveall
Use garp timer leaveall to set the GARP LeaveAll timer.
Use undo garp timer leaveall to restore the default. This may fail if the default is beyond the valid value
range for the LeaveAll timer.
Syntax
garp timer leaveall timer-value
undo garp timer leaveall
Default
The LeaveAll timer is 1000 centiseconds.
Views
System view
Default command level
2: System level
Parameters
timer-value: Specifies the Leaveall timer (in centiseconds), which must be a multiple of 5 and range from
the maximum Leave timer on the device (exclusive) to 32765 (inclusive).
Usage guidelines
To keep the dynamic VLANs learned through GVRP stable, do not set the LeaveAll timer smaller than its
default value.
Examples
# Set the leaveall timer to 2000 centiseconds, assuming that the Leave timer on every port is set to 60
centiseconds.
<Sysname> system-view
[Sysname] garp timer leaveall 2000
Related commands
• display garp timer
• garp timer leave
gvrp
Use gvrp to enable GVRP.
Use undo gvrp to disable GVRP.
Syntax
gvrp
undo gvrp
Default
GVRP is disabled.