R3303-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Command Reference

72
The stp point-to-point force-false or stp point-to-point force-true command configured on a port in MSTP
mode takes effect on all MSTIs.
If the physical link to which the port connects is not a point-to-point link but you set it to be one, the
configuration might bring a temporary loop.
Examples
# Configure the link connecting GigabitEthernet 4/0/3 as a point-to-point link.
<Sysname> system-view
[Sysname] interface GigabitEthernet 4/0/3
[Sysname-GigabitEthernet4/0/3] stp point-to-point force-true
Related commands
display stp
stp port priority
Use stp port priority to set the priority of the ports.
Use undo stp port priority to restore the default.
Syntax
stp [ instance instance-id ] port priority priority
undo stp [ instance instance-id ] port priority
Default
The port priority is 128.
Views
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
instance instance-id: Sets the priority of the ports in a particular MSTI. The value range for this argument
is 0 to 31. The value 0 represents the CIST.
priority: Port priority, which is in the range of 0 to 240 in increments of 16 (as indicated by 0, 16, 32).
Usage guidelines
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in port group view, the setting takes effect on all member ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
To set the priority of an MSTP port in a specific MSTI, use this command with the MSTI specified. To set
the priority of an MSTP port in the CIST or an STP or RSTP port, use this command without specifying any
MSTI.
Port priority affects the role of a port in a spanning tree.