R3303-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Configuration Guide

186
Ste
p
Command Remarks
4. Assign the port to all
CVLANs.
• As a trunk port:
port trunk permit vlan { vlan-list |
all }
• As a hybrid port:
port hybrid vlan vlan-list tagged
Use one of the commands.
By default:
• A trunk port is assigned to
only VLAN 1.
• A hybrid port is an
untagged member of
VLAN 1.
5. Enable basic QinQ.
qinq enable
By default, basic QinQ is
disabled.
6. Apply the uplink policy to
incoming traffic.
qos apply policy policy-name inbound N/A
7. Apply the downlink policy to
outgoing traffic.
qos apply policy policy-name outbound
N/A
Configuring the network-side port
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Ethernet
interface view.
• Enter Layer 2 Ethernet interface view:
interface interface-type interface-number
• Ethernet port group view:
port-group manual port-group-name
• Enter Layer 2 aggregate interface view:
interface bridge-aggregation
interface-number
N/A
3. Configure the link
type of the port.
• Configure the port as a trunk port:
port link-type trunk
• Configure the port as a hybrid port:
port link-type hybrid
Use one of the commands.
The default link type of an
Ethernet port is access.
4. Assign the port to all
CVLANs.
• As a trunk port:
port trunk permit vlan { vlan-list | all }
• As a hybrid port:
port hybrid vlan vlan-list tagged
Use one of the commands.
By default:
• A trunk port is assigned to
only VLAN 1.
• A hybrid port is an untagged
member of VLAN 1.
Configuring many-to-one VLAN mapping
Before changing VLAN mappings on a port, clear all DHCP snooping entries by using the reset
dhcp-snooping command (see Layer 3—IP Services Command Reference).
Perform many-to-one VLAN mapping on campus devices (see Figure 63) t
o transmit the same type of
traffic from different users in one VLAN.