R3303-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Configuration Guide

191
Ste
p
Command Remarks
5. Associate the class with
the behavior.
classifier tcl-name behavior behavior-name
mode dot1q-tag-manipulation
Repeat this step to create
class-behavior associations
for other CVLANs.
Configuring the customer-side port
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Ethernet port group view:
port-group manual
port-group-name
N/A
3. Configure the port as a hybrid
port.
port link-type hybrid
The default link type of an Ethernet
port is access.
4. Assign the port to the SVLANs
as an untagged member.
port hybrid vlan vlan-list untagged
By default, a hybrid port is an
untagged member of VLAN 1.
5. Enable basic QinQ.
qinq enable
By default, basic QinQ is disabled
on all ports.
6. Apply the uplink policy to
incoming traffic.
qos apply policy policy-name
inbound
N/A
Configuring the network-side port
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface
view.
• Enter Layer 2 Ethernet interface view:
interface interface-type interface-number
• Ethernet port group view:
port-group manual port-group-name
• Enter Layer 2 aggregate interface view:
interface bridge-aggregation
interface-number
N/A
3. Configure the link
type of the port.
• Configure the port as a trunk port:
port link-type trunk
• Configure the port as a hybrid port:
port link-type hybrid
The default link type of an Ethernet
port is access.