R3303-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Configuration Guide

39
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG AGG Partner ID Select Unselect Share
Interface Mode Ports Ports Type
-------------------------------------------------------------------------------
RAGG1 S none 2 0 Shar
RAGG2 S none 2 0 Shar
The output shows that link aggregation groups 1 and 2 are both load-shared Layer 3 static
aggregation groups and each contains two Selected ports.
# Display all the group-specific load-sharing criteria on Router A.
[RouterA] display link-aggregation load-sharing mode interface
Route-Aggregation1 Load-Sharing Mode:
source-ip address
Route-Aggregation2 Load-Sharing Mode:
destination-ip address
The output shows that the load sharing criterion for link aggregation group 1 is the source IP
address and the load sharing criterion for link aggregation group 2 is the destination IP address.