R3303-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

121
Default command level
2: System level
Parameters
slot slot-number: Specifies a card by its slot number.
Usage guidelines
After a card is specified to handle traffic for an HDLC link bundle interface, all traffic that arrives at the
bundle interface will be processed or forwarded by the card regardless of whether the receiving
interface is located on the card or not. If the card specified by this command is removed, traffic
forwarding failure results for the HDLC link bundle interface. After the card is re-installed, traffic
forwarding is restored.
You can use this function to achieve the following purposes:
• Alleviate the processing pressure on a card and make efficient use of processing capabilities of
service cards.
• Avoid the change of processing card caused by the selected state changes of member interfaces
that are located on different cards.
The following matrix shows the command and router compatibility:
Command 6602 HSR6602 6604/6608/6616
service No Yes Yes
Examples
# Specify the card in slot 2 to process or forward traffic for interface HDLC-bundle 1.
<Sysname> system-view
[Sysname] interface hdlc-bundle 1
[Sysname-Hdlc-bundle1] service slot 2
shutdown
Use shutdown to shut down an HDLC link bundle interface.
Use undo shutdown to bring up an HDLC link bundle interface.
Syntax
shutdown
undo shutdown
Default
An HDLC link bundle interface is up.
Views
HDLC link bundle interface view
Default command level
2: System level