R3303-HP 6600/HSR6600 Routers Layer 3 - IP Routing Command Reference

120
Usage guidelines
A device that has OSPF NSR enabled cannot act as a GR restarter. The graceful-restart command and
the ospf non-stop-routing command are mutually exclusive and cannot be configured on a device at the
same time.
The following matrix shows the command and router compatibility:
Command 6602 HSR6602 6604/6608/6616
ospf non-stop-routing No No
• Yes when using the RPE-X1 or RSE-X1
MPU
• No when using the MCP MPU
Examples
# Enable OSPF NSR.
<Sysname> system-view
[Sysname] ospf non-stop-routing
ospf packet-process prioritized-treatment
Use ospf packet-process prioritized-treatment to enable OSPF to give priority to receiving and
processing Hello packets.
Use undo ospf packet-process prioritized-treatment to restore the default.
Syntax
ospf packet-process prioritized-treatment
undo ospf packet-process prioritized-treatment
Default
This function is not enabled.
Views
System view
Default command level
2: System level
Examples
# Enable OSPF to give priority to receiving and processing Hello packets.
<Sysname> system-view
[Sysname] ospf packet-process prioritized-treatment
ospf timer dead
Use ospf timer dead to set the dead interval.
Use undo ospf timer dead to restore the default.
Syntax
ospf timer dead seconds