R3303-HP 6600/HSR6600 Routers Layer 3 - IP Routing Command Reference

281
[Sysname] bgp 100
[Sysname-bgp] peer test reflect-client
# In BGP-VPN instance view, configure the local device as a route reflector and specify the IBGP peer
group test as a client. (vpn1 must have been created.)
<Sysname> system-view
[Sysname] bgp 109
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] peer test reflect-client
Related commands
• reflect between-clients
• reflect cluster-id
peer route-limit (BGP/BGP-VPN instance view)
Use peer route-limit to specify the maximum number of routes that can be received from a peer or peer
group.
Use undo peer route-limit to cancel the configuration.
Syntax
peer { group-name | ip-address } route-limit prefix-number [ { alert-only | reconnect reconnect-time } |
percentage-value ] *
undo peer { group-name | ip-address } route-limit
Default
The number of routes that can be received from a peer or peer group is not limited.
Views
BGP view, BGP-VPN instance view
Default command level
2: System level
Parameters
group-name: Specifies the name of a peer group, a string of 1 to 47 characters.
ip-address: Specifies the IP address of a peer.
prefix-number: Specifies the number of prefixes that can be received from the peer or peer group. If the
number of prefixes received from the peer/peer group reaches the prefix-number, the router will tear
down the connection to the peer/peer group.
alert-only: If the number of prefixes received from the peer/peer group reaches the prefix-number, the
router will not tear down the connection to the peer/peer group but display an alarm message.
reconnect reconnect-time: Specifies a reconnect time, after which, the router re-establishes a connection
to the peer/peer group. It has no default value and is in the range of 1 to 65535 seconds.
percentage-value: Specifies the threshold value for the router to display an alarm message (the router
displays an alarm message when the ratio of the number of received prefixes to the prefix-number
exceeds the percentage). It is in the range of 1 to 100 and defaults to 75.
The following matrix shows the value ranges for the prefix-number argument: