R3303-HP 6600/HSR6600 Routers Layer 3 - IP Routing Configuration Guide

139
The operation mode of LSP fragment extension is configured based on area and routing level.
Mode-1 allows the routers supporting and not supporting LSP fragment extension to interoperate
with each other, but it restricts the link state information in the extended fragments. Mode-2 does
not restrict the link state information in the extended fragments, and is recommended for an area
where all the routers are at the same routing level and support LSP fragment extension.
Dynamic host name mapping mechanism
The dynamic host name mapping mechanism provides the mappings between the host names and the
system IDs for the IS-IS routers. The dynamic host name information is announced in the dynamic host
name CLV of an LSP.
This mechanism also provides the mapping between a host name and the DIS of a broadcast network,
which is announced in the dynamic host name TLV of a pseudonode LSP.
A host name is easier to remember than a system ID. After enabling this feature on the router, you can see
the host names instead of system IDs by using the display command.
BFD
BFD provides a single mechanism to quickly detect any link failures between IS-IS neighbors to reduce
network convergence time.
For more information about BFD, see High Availability Configuration Guide.
MTR
IS-IS Multi-Topology Routing (MTR) splits an IS-IS routing domain into multiple independent IP topologies,
such as an IPv4 topology and an IPv6 topology. SPF computation is performed on a per-topology basis.
IS-IS MTR comprises:
• IPv4 unicast MTR.
• IPv6 unicast MTR. For relevant information, see "Configuring IPv6 IS-IS."
For more information about MTR, see "Configuring MTR."
Protocols and standards
• ISO 10589, ISO IS-IS Routing Protocol
• ISO 9542, ES-IS Routing Protocol
• ISO 8348/Ad2, Network Services Access Points
• RFC 1195 , Use of OSI IS-IS for Routing in TCP/IP and Dual Environments
• RFC 2763, Dynamic Hostname Exchange Mechanism for IS-IS
• RFC 2966, Domain-wide Prefix Distribution with Two-Level IS-IS
• RFC 2973, IS-IS Mesh Groups
• RFC 3277, IS-IS Transient Blackhole Avoidance
• RFC 3358, Optional Checksums in ISIS
• RFC 3373, Three-Way Handshake for IS-IS Point-to-Point Adjacencies
• RFC 3567, Intermediate System to Intermediate System (IS-IS) Cryptographic Authentication
• RFC 3719, Recommendations for Interoperable Networks using IS-IS
• RFC 3786, Extending the Number of IS-IS LSP Fragments Beyond the 256 Limit
• RFC 3787, Recommendations for Interoperable IP Networks using IS-IS