R3303-HP 6600/HSR6600 Routers MPLS Command Reference Guide

128
Parameters
ip-address1 ip-address2: Substitutes the IP address specified by the ip-address2 argument for the IP
address specified by the ip-address1 argument in the explicit path. The specified IP addresses can be link
IP addresses or router IDs of nodes.
include: Includes the node ip-address2 on the explicit path.
loose: Specifies the node ip-address2 as a loose node, which means that ip-address2 and its previous
hop can be connected indirectly.
strict: Specifies the node ip-address2 as a strict node, which means that ip-address2 and its previous hop
must be connected directly.
exclude: Excludes the node ip-address2 from path calculations for the explicit path.
Usage guidelines
• If you specify neither include nor exclude, the include keyword is used by default.
• If you specify neither loose nor strict, the strict keyword is used by default.
Examples
# Replace IP address 10.0.0.125 with IP address 10.0.0.200 for the explicit path path1 and exclude this
new IP address from path calculations.
<Sysname> system-view
[Sysname] explicit-path path1
[Sysname-explicit-path-path1] modify hop 10.0.0.125 10.0.0.200 exclude
mpls rsvp-te
Use mpls rsvp-te to enable RSVP-TE.
Use undo mpls rsvp-te to disable RSVP-TE.
Syntax
mpls rsvp-te
undo mpls rsvp-te
Default
RSVP-TE is disabled.
Views
MPLS view, interface view
Default command level
2: System level
Usage guidelines
You must enable RSVP-TE before you can configure other RSVP-TE features.
Before enabling RSVP-TE in MPLS view on a node, enable MPLS in system view and MPLS TE in MPLS
view.
Before enabling RSVP-TE in interface view, enable MPLS and MPLS TE in interface view.
Disabling RSVP-TE in MPLS view also disables RSVP-TE on interfaces.