R3303-HP 6600/HSR6600 Routers MPLS Command Reference Guide

164
Use undo mpls te reoptimization to disable reoptimization on the tunnel.
Syntax
mpls te reoptimization [ frequency seconds ]
undo mpls te reoptimization
Default
Reoptimization is disabled.
Views
Tunnel interface view
Default command level
2: System level
Parameters
frequency seconds: Specifies reoptimization frequency in the range of 1 to 604800 seconds. The default
is 3600 seconds, or 1 hour.
Usage guidelines
The reoptimization function cannot be used together with these commands: mpls te auto-bandwidth
adjustment, mpls te route-pinning, mpls te backup, and mpls te resv-style ff.
Examples
# Enable reoptimization, setting the reoptimization (automatic rerouting) frequency to 43200 seconds
(12 hou rs) .
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te reoptimization frequency 43200
mpls te reoptimization (user view)
Use mpls te reoptimization to start reoptimizing all reoptimization-enabled TE tunnels.
Syntax
mpls te reoptimization
Views
User view
Default command level
2: System level
Examples
# Start reoptimizing all reoptimization-enabled TE tunnels.
<Sysname> mpls te reoptimization
mpls te resv-style
Use mpls te resv-style to set the resource reservation style for the MPLS TE tunnel.
Use undo mpls te resv-style to restore the default.