R3303-HP 6600/HSR6600 Routers MPLS Command Reference Guide

171
mpls te tunnel-id
Use mpls te tunnel-id to configure the tunnel ID.
Syntax
mpls te tunnel-id tunnel-id
Views
Tunnel interface view
Default command level
2: System level
Parameters
tunnel-id: Specifies a tunnel ID. For the value range, see the matrix table in the Usage guidelines.
The following matrix shows the value ranges for the tunnel-id argument:
6602 HSR6602 6604/6608/6616
0 to 256 0 to 256
• With the RSE-X1 MPU: 0 to 1024
• With other MPUs: 0 to 256
Usage guidelines
Configure the tunnel ID before issuing the mpls te commit command for the first time. Otherwise, the
tunnel cannot be created.
Once configured, a tunnel ID cannot be removed. To change a tunnel ID, remove the tunnel, reconfigure
the tunnel, and specify a new tunnel ID.
Examples
# Configure the tunnel ID as 100.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te tunnel-id 100
mpls te vpn-binding
Use mpls te vpn-binding to define the traffic to be forwarded along the MPLS TE tunnel. You can specify
the tunnel to forward only the VPN traffic that matches the specified ACL or forward only the traffic of the
specified VPN.
Use undo mpls te vpn-binding to restore the default.
Syntax
mpls te vpn-binding { acl acl-number | vpn-instance vpn-instance-name }
undo mpls te vpn-binding
Default
No restriction is defined about what traffic can travel down a TE tunnel.
Views
Tunnel interface view