R3303-HP 6600/HSR6600 Routers MPLS Command Reference Guide

10
Field Descri
p
tion
MTU Signaling
Indicates whether MTU signaling is supported. The device does not
support MTU signaling.
Recovery Timer Setting of the GR's recovery timer.
Nonstop Routing
State of LDP NSR:
• On—LDP NSR is enabled but the data backup is not finished yet.
• Off—LDP NSR is disabled.
• Ready—LDP NSR is enabled and data backup is finished.
Instance ID Sequence number of the LDP instance.
VPN-Instance
Instance name of the LDP-enabled VPN. For the default VPN, this field
is blank.
Hop Count Limit Maximum hop count for loop detection.
Path Vector Limit Maximum path vector length.
Loop Detection Indicates whether loop detection is enabled.
DU Re-advertise Timer Label re-advertisement interval for DU mode.
DU Re-advertise Flag Indicates whether label re-advertisement is enabled for DU mode.
DU Explicit Request
Indicates whether explicit request transmission is enabled for DU
mode.
Request Retry Flag Indicates whether request retransmission is enabled.
Label Distribution Mode
Label distribution control mode of the instance: Ordered or
Independent.
Label Retention Mode
Label retention mode used by the instance. The device only supports
the Liberal mode.
Related commands
• mpls ldp (interface view)
• mpls ldp (system view)
display mpls lsp bfd ipv4
Use display mpls lsp bfd ipv4 to display BFD information for LSPs.
Syntax
display mpls lsp bfd [ ipv4 destination-address mask-length ] [ | { begin | exclude | include }
regular-expression ]
Views
Any view
Default command level
1: Monitor level