R3303-HP 6600/HSR6600 Routers MPLS Command Reference Guide

221
Default command level
2: System level
Parameters
mtu-value: Specifies the MTU for the L2VPN, in the range of 128 to 1500.
Usage guidelines
HP does not recommends not using the mtu command, because it affects only parameter negotiations
between PEs and does not instruct traffic forwarding.
Examples
# Set the MPLS L2VPN MTU to 1000.
<Sysname> system-view
[Sysname] mpls l2vpn vpn1
[Sysname-mpls-l2vpn-vpn1] mtu 1000
pw-class
Use pw-class to create a PW class and enter PW class view.
Use undo pw-class to delete an existing PW class.
Syntax
pw-class class-name
undo pw-class class-name
Default
No PW class is created.
Views
System view
Default command level
2: System level
Parameters
class-name: Specifies a name for the PW class, a case-insensitive string of 1 to 19 characters.
Usage guidelines
To create multiple VCs with the same attributes (such as VC type and VC tunneling policy), you do not
need to configure the attributes one by one for each VC. Instead, you can create a PW class, configure
VC attributes in the PW class, and then reference the PW class in each VC.
Examples
# Create PW class pw100 and enter its view.
<Sysname> system-view
[Sysname] pw-class pw100
[Sysname-pw-pw100]