R3303-HP 6600/HSR6600 Routers MPLS Configuration Guide

314
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 34/48/72 ms
[CE1] ping 10.4.1.1
PING 10.4.1.1: 56 data bytes, press CTRL_C to break
Request time out
Request time out
Request time out
Request time out
Request time out
--- 10.4.1.1 ping statistics ---
5 packet(s) transmitted
0 packet(s) received
100.00% packet loss
Configuring MPLS L3VPNs using IBGP between a PE and a CE
Network requirements
CE 1 and CE 3 belong to VPN 1. CE 2 and CE 4 belong to VPN 2.
VPN 1 uses route target attribute 111:1. VPN 2 uses route target attribute 222:2. Users of different VPNs
cannot access each other.
IBGP is used to exchange VPN routing information between CE and PE.
PEs use OSPF to communicate with each other and use MP-IBGP to exchange VPN routing information.
Figure 87 Network diagram
Device Interface IP address Device Interface IP address
PE 1 Loop0 1.1.1.9/32 PE 2 Loop0 3.3.3.9/32
GE2/1/1 10.1.1.2/24 GE2/1/1 10.3.1.2/24
GE2/1/2 10.2.1.2/24 GE2/1/2 10.4.1.2/24
POS5/1/1 172.1.1.1/24 POS5/1/1 172.2.1.2/24