R3303-HP 6600/HSR6600 Routers Network Management and Monitoring Command Reference

95
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
If IPC performance statistics is enabled, the command displays the current IPC performance statistics. If
IPC performance statistics is disabled, the command displays the IPC performance statistics collected
before IPC performance statistics was disabled.
Examples
# Display the IPC performance statistics for node 6.
<Sysname> display ipc performance node 6
Peak: Peak rate (pps)
10Sec: Average rate in the last 10 seconds (pps)
1Min: Average rate in the last 1 minute (pps)
5Min: Average rate in the last 5 minutes (pps)
Total-Data: Total number of data (packets)
Statistics for packets sent successfully:
Peak 10Sec 1Min 5Min Total-Data
------------------------------------------------------------
1 1 1 0 80
Statistics for packets received successfully:
Peak 10Sec 1Min 5Min Total-Data
------------------------------------------------------------
1 1 1 0 82
Statistics for packets acknowledged:
Peak 10Sec 1Min 5Min Total-Data
------------------------------------------------------------
1 1 1 0 78
Table 20 Command output
Field Descri
p
tion
Peak
Peak rate in pps (average rate is computed every 10 seconds,
and the greatest average rate is taken as the peak rate).
10Sec Average rate (in pps) in the last 10 seconds.
1Min Average rate (in pps) in the last 1 minute.
5Min Average rate (in pps) in the last 5 minutes.
Total-Data
Total amount of data collected from the time when IPC
performance statistics was enabled to the time when this
command is executed.
Related commands
ipc performance enable
display ipc queue
Use display ipc queue to display output queue information for the specified node.