R3303-HP 6600/HSR6600 Routers Network Management and Monitoring Configuration Guide

191
Ste
p
Command Remarks
2. Enable Host-monitor. host-monitor { inbound | outbound }
By default, Host-monitor is
disabled.
Make sure Host-monitor is
enabled in the same traffic
direction as Netstream.
Freezing legitimate flow entries
To freeze legitimate flow entries in the host monitor table:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
Freeze legitimate flow
entries in the host monitor
table.
host-monitor [slot slot-number ]
By default, the flow
entries are in
Unfixed state.
Adding legitimate flow entries
Ste
p
Command
1. Enter system view.
system-view
2. Add a legitimate flow
entry.
host-monitor add source source-ip destination destination-ip protocol protocol
interface interface-type interface-number { inbound | outbound } [ vpn-instance
vpn-instance-name ] [ slot slot-number ]
Deleting a legitimate flow entry
To delete a fixed or unfixed legitimate flow entry:
Ste
p
Command
1. Enter system view.
system-view
2. Delete a legitimate
flow entry.
host-monitor delete source source-ip destination destination-ip protocol protocol
interface interface-type interface-number { inbound | outbound } [ vpn-instance
vpn-instance-name ] [ slot slot-number ]
Deleting unfixed flow entries
To delete all unfixed flow entries, perform the following task in user view: