R3303-HP 6600/HSR6600 Routers Fundamentals Configuration Guide

108
Ste
p
Command Remarks
1. Verify that a next-startup
configuration file has
been specified in user
view.
display startup
Optional.
If no next-startup configuration file has
been specified, the backup operation will
fail.
2. Back up the next-startup
configuration file to a TFTP
server in user view.
backup startup-configuration
to dest-addr [dest-filename ]
This command is not supported in FIPS
mode.
.
Restoring the next-startup configuration file from a
TFTP server
To download a configuration file from a TFTP server to the device and specify the file as the next-startup
configuration file in one step, perform the task in this section.
This task restores only the main next-startup configuration file.
Before restoring the next-startup configuration file, make sure the following requirements are met:
• The server is reachable and enabled with TFTP service.
• You have read and write permissions.
To restore the main next-startup configuration file from a TFTP server:
Ste
p
Command Remarks
1. Restore the main next-startup
configuration file from a
TFTP server in user view.
restore
startup-configuration
from src-addr
src-filename
This command is not supported in FIPS mode.
File destination:
• 6604/6608/6616—cfa0:/ on each MPU.
• 6602—cfa0:/.
• HSR6602—flash:/.
2. Verify that the specified
configuration file has been
set as the main next-startup
configuration file.
display startup Optional.
Deleting the next-startup configuration file
CAUTION:
• On the 6602/HSR6602 router, this task permanently deletes the next-startup confi
g
uration file from the
device. Before performing this task, back up the file as needed.
• On the 6604/6608/6616 router, this task permanently deletes the next-startup confi
g
uration file from
each MPU. Before performing this task, back up the file as needed.