R3303-HP 6600/HSR6600 Routers Interface Configuration Guide

51
Ste
p
Command Remarks
2. Enter interface view.
• Enter POS interface view:
interface pos
interface-number
• Enter Layer 3 GigabitEthernet
interface view:
interface gigabitethernet
interface-number
To change a POS interface to an Ethernet
interface, enter POS interface view. To
change an Ethernet interface to a POS
interface, enter Ethernet interface view.
3. Change the interface
type.
port-type switch interface-type
The device returns to system view
automatically after you execute this
command.
Configuring the operating mode of a POS interface
card
Some POS interface cards support multiple operating modes. You can change their operating modes as
needed. For more information about the operating modes of interface cards, see Fundamentals
Configuration Guide.
Displaying and maintaining POS interfaces
Task Command Remarks
Display information
about one or all POS
interfaces.
display interface [ pos ] [ brief [ down ] ] [ | { begin |
exclude | include } regular-expression ]
display interface pos interface-number [ brief
[ description ] ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.
Clear statistics of one or
all POS interfaces.
reset counters interface [ pos [ interface-number ] ] Available in user view.
POS interface configuration example
Directly connecting routers through POS interfaces
Network requirements
As shown in Figure 5, use a pair of single mode optic fibers (for receiving and sending data, respectively)
to connect the POS interfaces on Router A and Router B.
Encapsulate the interfaces with PPP.