HP 6600 Router Series - HP A6600_HSR6602-CMW520-R3103P02 Release Notes Release Notes

 Condition: This symptom occurs when the following conditions exist:

The router has two MPUs.

OSPF NSR is enabled.

An OSPF default route exists.

RTD066144

 Symptom: When the DHCP relay agent on the A6600 receives a DHCP packet in which the length

value in Option 82 is larger than the actual field length, the A6600 reboots.

 Condition: This symptom occurs when the DHCP relay agent on the A6600 receives a DHCP packet

in which the length value in Option 82 is larger than the actual field length.

RTD066403

 Symptom: When session control is enabled on the AAA server and a RADIUS key is configured on

A6600, users might fail to get online.

 Condition: This symptom might occur when session control is enabled on the AAA server and a

RADIUS key is configured on A6600.

RTD066571

 Symptom: When the security policy server is enabled on IMC and the A6600 acts as the portal

gateway, an iNode client passes security policy authentication and can access the network. After

a certain time, the iNode client fails to pass security policy authentication and cannot access the

network.

 Condition: This symptom occurs when the security policy server is enabled on IMC and the A6600

acts as the portal gateway.

Resolved Problems in CMW520-R3103P01

RTD065718

 Symptom: After portal authentication has run for one day, it stops working, and users can access

the network without being authenticated. This problem might occur earlier if more traffic exists.

 Condition: This symptom can be seen after portal authentication has run for one day or less.

RTD066128

 Symptom: After a distributed device MPU is rebooted or its line card is rebooted, logical interface

cannot pass the IPSec negotiation.

 Condition: This symptom might occur after MPU or line card rebooted, and the IPSEC is configured

on the logical interface.

RTD065758

 Symptom: The port rate displayed on the network management software is not correct.

 Condition: This symptom occurs if the virtual-baudrate is not the default value on the router that

functions as a DTE device.