HP 6600 Router Series - HP A6600_HSR6602-CMW520-R3103P02 Release Notes Release Notes

Resolved Problems in CMW520-R2604P05

RTD063021

 Symptom: LACP might fail to be enabled on a port.

 Condition: This symptom might occur on a port if the following procedure is performed:

 Remove the port from a link aggregation group when the port is shut down.

 Enable the port and add it another link aggregation group.

 Update the members in the original link aggregation group.

RTD063369

 Symptom: Some AAA servers cannot filter users by IMSI and SN.

 Condition: This symptom might occur when user filtering based on IMSI and SN is configured on

some AAA servers.

RTD063390

 Symptom: BGP route flaps might occur if many BGP routes with multiple attributes are updated

through a complicated routing policy.

 Condition: This symptom might occur if many BGP routes with multiple attributes are updated

through a complicated routing policy.

RTD063504

 Symptom: An A6600 router configured with an ACG card cannot be pinged from a directly

connected PC, and the running routing protocol cannot create neighbors.

 Condition: This symptom might occur if an ACFP policy with the source or destination port specified

as "any" is configured.

Resolved Problems in CMW520-R2604P04

RTD062419

 Symptom: The tunnel interface cannot deal with the bandwidth change.

 Condition: Modify the bandwidth of tunnel interface.

RTD062421

 Symptom: Get the value of ‘lldpRemSysName’, the return value is ‘No Such Instance’.

 Condition: There are LLDP neighbors of the port and set ‘TimeFilter’ to zero.

RTD062498

 Symptom: The remark cannot work correctly after the ACL was modified.

 Condition: The if-match of traffic classifier is bound to ACL name.

RTD062785

 Symptom: OSPF cannot configure neighbors more than 200.

 Condition: None.