HP HSR 6600 Router Series - HP A6600_HSR6602-CMW520-R3103P04 Release Notes Release Notes

19
RTD062421
 Symptom: Get the value of ‘lldpRemSysName’, the return value is ‘No Such Instance’.
 Condition: There are LLDP neighbors of the port and set ‘TimeFilter’ to zero.
RTD062498
 Symptom: The remark cannot work correctly after the ACL was modified.
 Condition: The if-match of traffic classifier is bound to ACL name.
RTD062785
 Symptom: OSPF cannot configure neighbors more than 200.
 Condition: None.
Resolved Problems in CMW520-R2604P02
RTD061176
 Symptom: In the IMC display, the interface status is showed always DOWN if the interface belongs
to a link-aggregation group, in fact it is actually UP and passing data.
 Condition: None.
RTD061265
 Symptom: The link message cannot be deal with correctly, when the ICCN package does not
contain the AVP associate with proxy.
 Condition: Configure L2TP at A6600.
RTD061334
 Symptom: A6600 will ignore those routes with 0.0.0.0 address and miss them in BGP table.
 Condition: BGP peer advertise aggregation route with 0.0.0.0 attribute.
RTD061341
 Symptom: BGP route flapping occurs and persists for a long time. Traffic is interrupted.
 Condition: In a ring network, multiple BGP route reflectors and large numbers of BGP routes exist.
Then a port on the ring network goes up and down.
RTD061371
 Symptom: The command ‘display connection’ can only display 10 results.
 Condition: RPE-X1 is configured in the A6600.
RTD061451
 Symptom: There is data loss when the data path is through the interfaces on the FIP-200.
 Condition: RPE-X1 is configured in the A6600, link-aggregation group with members on different
FIP boards and netstream are configured at same time.
RTD061452
 Symptom: The interface cannot link UP after restarted.
 Condition: The fixed interface of FIP-110 is configured as ‘combo enable fiber, duplex full, speed
1000’.