R3102-R3103-HP 6600/HSR6600 Routers Fundamentals Command Reference

130
O
p
tion 6602 HSR6602 6604/6608/6616
slot slot-number No
Yes (fixed at 0, which
specifies the current device)
Yes
main: Specifies the file as the main system software image. The main system software image has higher
priority than the backup system software image at startup.
backup: Specifies the file as the backup system software image. The backup system software image is
used at startup only if the main system software image is unavailable.
Usage guidelines
• 6602/HSR6602:
To execute the command successfully, make sure you have saved the image file to the root
directory of a storage medium on the device.
• 6604/6608/6616:
To execute the command successfully, make sure you have saved the image file to the root
directory of a storage medium on the MPU.
Names of the startup system software image files on MPUs can be different, but their versions must
be the same for a correct startup.
In FIPS mode, the file must pass authenticity verification before it can be set as a startup system software
image file.
Examples
# On the 6602 router, specify test.bin as the main startup system software image file.
<Sysname> boot-loader file test.bin main
This command will set the boot file. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot 0!
# On the HSR6602 router, specify hsr6602_mcp.bin as the main startup system software image file.
<Sysname>boot-loader file sr6602x_mcp.bin slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified
f
ile will be used as the main boot file at the next reboot on slot 0!
<Sysname>
# On the 6604/6608/6616 router, specify test.bin as the main startup system software image file for the
active MPU (in slot 0). This example assumes that this file has been saved in the root directory of the
storage medium on the active MPU.
<Sysname> boot-loader file test.bin slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot 0!
# On the 6604/6608/6616 router, specify test.bin as the main startup system software image file for the
standby MPU (in slot 1). This example assumes that this file has been saved in the root directory of the
storage medium on the standby MPU.
<Sysname> boot-loader file slot1#cfa0:/test.bin slot 1 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot 1!
Related commands
display boot-loader