R3102-R3103-HP 6600/HSR6600 Routers Fundamentals Command Reference

173
On an 6604, 6608, or 6616, this command displays the mode of the last reboot of the active MPU if no
card is specified.
Examples
# Display the mode of the last reboot.
<Sysname> display reboot-type
The rebooting type this time is: Cold
The output shows that the last reboot mode is Cold boot (cold boot will restart a device by powering it on).
(The display of Warm represents a warm boot, which means to restart a device by using the commands
like reboot).
display rps
Use display rps to display RPS status information.
Syntax
display rps [ rps-id ] [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
rps-id: Displays the status of the specified RPS, where rps-id represents the RPS number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
The following matrix shows the command and router compatibility:
Command 6602 HSR6602 6604/6608/6616
display rps Yes No No
Examples
# Display RPS status information.
<Sysname> display rps
RPS 2 State: Normal
The output shows that RPS 2 is operating correctly.