R3102-R3103-HP 6600/HSR6600 Routers Fundamentals Command Reference

34
Before using the redirect function or configuring redirect service related parameters, use this command to
enable redirect.
The stop bit setting must be the same for the user interfaces of the connecting ports on the device and the
target terminal device for communication.
Examples
# Enable redirect on user interface AUX 0.
<Sysname> system-view
[Sysname] user-interface aux 0
[Sysname-ui-aux0] redirect enable
Related commands
• redirect listen-port
• shell
• stopbits
Related commands
• telnet
• display tcp status
redirect listen-port
Use redirect listen-port to specify a Telnet redirect listening port.
Use undo redirect listen-port to restore the default listening port.
Syntax
redirect listen-port port-number
undo redirect listen-port
Default
The port number is the absolute user interface number plus 2000.
Views
User interface view
Default command level
2: System level
Parameters
port-number: Specifies a port number in the range 2000 to 50000.
Usage guidelines
This command is supported only on AUX user interfaces.
This command is applicable to user interfaces on which redirect is enabled. To enable redirect on a user
interface, use the redirect enable command.
Examples
# Configure port 3000 as the listening port for the redirected Telnet connections.
<Sysname> system-view
[Sysname] user-interface aux 0