R3102-R3103-HP 6600/HSR6600 Routers High Availability Command Reference

94
reset rpr protection statistics
Use reset rpr protection statistics to clear RPR protection events statistics.
Syntax
reset rpr protection statistics [ rpr interface-number ]
Views
User view
Default command level
1: Monitor level
Parameters
rpr interface-number: Specifies an RPR logical interface by its type and number. If no RPR logical
interface is specified, the RPR protection events statistics for the RPR stations corresponding to all the RPR
logical interfaces on your device are cleared.
Examples
# Clear all RPR protection events statistics.
<Sysname> reset rpr protection statistics
rpr admin-request
Use rpr admin-request to send an RPR protection request on the specified ringlet.
Syntax
rpr admin-request { fs | idle | ms } { ringlet0 | ringlet1 }
Default
Idle protection applies.
Views
Layer 3 RPR logical interface view
Default command level
2: System level
Parameters
fs: Sends a forced switch (FS) protection request.
idle: Sends an idle protection request.
ms: Sends a manual switch (MS) protection request.
ringlet0: Sends a protection request on Ringlet 0.
ringlet1: Sends a protection request on Ringlet 1.
Usage guidelines
Six types of protection requests, FS, signal fail (SF), signal degrade (SD), MS, wait to restore (WTR), and
idle, are available with decreased priorities. Among them, FS and MS requests are sent manually,
whereas SF, SD, and WTR requests are sent automatically.