R3102-R3103-HP 6600/HSR6600 Routers High Availability Configuration Guide

98
Figure 26 Network diagram
Configuration procedure
1. Configure Router A:
# Create VLANs 1 through 30, map these VLANs to MSTI 1, and activate the MST region
configuration.
<RouterA> system-view
[RouterA] vlan 1 to 30
[RouterA] stp region-configuration
[RouterA-mst-region] instance 1 vlan 1 to 30
[RouterA-mst-region] active region-configuration
[RouterA-mst-region] quit
# Set the physical state change suppression interval to 0 seconds on GigabitEthernet 3/0/1
through GigabitEthernet 3/0/4. Disable the spanning tree feature, configure the four ports as
trunk ports, and assign them to VLANs 1 through 30.
[RouterA] interface gigabitethernet 3/0/1
[RouterA-GigabitEthernet3/0/1] link-delay 0
[RouterA-GigabitEthernet3/0/1] undo stp enable
[RouterA-GigabitEthernet3/0/1] port link-type trunk
[RouterA-GigabitEthernet3/0/1] port trunk permit vlan 1 to 30
[RouterA-GigabitEthernet3/0/1] quit
[RouterA] interface gigabitethernet 3/0/2
[RouterA-GigabitEthernet3/0/2] link-delay 0
[RouterA-GigabitEthernet3/0/2] undo stp enable
[RouterA-GigabitEthernet3/0/2] port link-type trunk
[RouterA-GigabitEthernet3/0/2] port trunk permit vlan 1 to 30
[RouterA-GigabitEthernet3/0/2] quit
[RouterA] interface gigabitethernet 3/0/3
[RouterA-GigabitEthernet3/0/3] link-delay 0
[RouterA-GigabitEthernet3/0/3] undo stp enable
Ring 2
Ring 3
Ring 4
Ring 5
Ring 1
Router A
Edge node & master node
Router D
Edge node
Router G
Master node
Router H
Master node
Router C
Assistant edge node
Router B
Assistant edge node
Router F
Master node
GE3/0/1
GE3/0/2
GE
3
/
0
/
2
GE3/0/1
GE3/0/1
GE3/0/2
GE
3
/
0
/
1
GE
3
/0/2
GE3/0/2
GE3/0/1
GE3/0/4
GE3
/
0/3
GE3/0/1
GE3/0/2
GE
3
/
0
/
4
GE3/0/3
GE3/0/2
GE3/0/1
GE3/0/3
GE
3/
0
/
4
GE3/0/2
GE3/0/1 GE3/0/4
GE
3
/
0
/
3
Router E
Master node
Domain 1