R3102-R3103-HP 6600/HSR6600 Routers Interface Command Reference

210
Field Descri
p
tion
Frame-format SDH, multiplex AU-3,
clock master, loopback not set
Physical layer information of the CPOS interface: the framing format
is set to SDH, AU-3 path is adopted, master clock (internal clock
signal) is used, and loopback is disabled.
SD threshold: 6 , SF threshold: 3 SD threshold and SF threshold of the CPOS interface.
Optical Transmission medium.
Tx: J0: 0x01 Sent overhead bytes.
Rx: J0: 0x01 Received overhead bytes.
Regenerator section: Alarm and error statistics about the regenerator section.
Multiplex section: Alarm and error statistics about the multiplex section.
Higher order path(VC-3-x):
Alarm and error statistics about the higher-order path. The x in
"VC-3-x" indicates the path number. When adopting AU-3 path,
one STM-1 has three higher-order paths because it is multiplexed by
three VC-3s. In the AU-4 path, there is one higher-order path VC-4.
Alarm: Alarm statistics.
Error: Error statistics.
Cpos2/0/0 CT1 1 is up
Current physical state of T1 channel 1 of the CPOS interface
2/0/0.
Frame-format ESF, clock master,
loopback not set
Physical layer information of T1 channels: the framing format is set
to ESF, master clock (internal clock signal) is used, and loopback is
disabled.
Related commands
• display controller cpos e1
• display controller cpos t1
display controller cpos e1
Use display controller cpos e1 to display the physical layer configuration information of the specified E1
channel on the specified CPOS interface.
Syntax
display controller cpos cpos-number e1 e1-number [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
cpos-number: CPOS interface number.
e1-number: Number of an E1 channel on the specified CPOS interface, in the range of 1 to 63.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.