R3102-R3103-HP 6600/HSR6600 Routers Interface Command Reference

214
Field Descri
p
tion
E3 1 is up State of the E3 channel. In this sample output, the state of E3 channel 1 is up.
Frame-format Framing format on the E3 channel.
Clock Clock mode of the E3 channel.
Loopback Loopback mode of the E3 channel.
national-bit National bit value of the E3 channel.
Alarm Alarms on the E3 channel.
Error Error counts on the E3 channel.
display controller cpos t1
Use display controller cpos t1 to display the physical layer configuration information of the specified T1
channel on the specified CPOS interface.
Syntax
display controller cpos cpos-number t1 t1-number [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
cpos-number: CPOS interface number.
t1-number: Number of a T1 channel on the specified CPOS interface, in the range of 1 to 84.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
Different from the display controller cpos command, this command can display the error and alarm
information of lower-order paths and T1 frames.
Examples
# Display the status information of T1 channel 2 on interface CPOS 2/0/0.
<Sysname> display controller cpos 2/0/0 t1 2
Cpos2/0/0 current state : UP Frame-format SDH, multiplex AU-3, clock master, loopback
not set
Tx: J0: 0x01
Rx: J0: 0x01
Regenerator section: