R3102-R3103-HP 6600/HSR6600 Routers Interface Command Reference

215
Alarm: none
Error: 0 BIP, 0 SEF
Multiplex section:
Alarm: none
Error: 0 BIP, 0 REI
Higher order path(VC-3-2):
Alarm: none
Error: 0 BIP, 0 REI
Lower order path:
Alarm: none
Error: 4095 BIP, 2047 REI
Cpos2/0/0 CT1 2 is up
Frame-format ESF, clock master, loopback not set
T1 framer(2-1-1):
Alarm: none
Error: 4095 FERR, 79 AERR
Table 29 Command output
Field Descri
p
tion
Cpos2/0/0 current state Current physical state of the CPOS interface.
Frame-format SDH, multiplex AU-3,
clock master, loopback not set
Physical layer information of the CPOS interface. The framing format is
set to SDH, AU-3 path is adopted, master clock (internal clock signal) is
used, and loopback is disabled.
Tx: J0: 0x01 Sent overhead bytes.
Rx: J0: 0x01 Received overhead bytes.
Regenerator section Alarm and error statistics about the regenerator section.
Multiplex section Alarm and error statistics about the multiplex section.
Higher order path(VC-3-2)
Alarm and error statistics about the higher-order path to which the T1
channel belongs. VC-3-2 means the second VC-3.
Lower order path Alarm and error statistics about the lower-order path.
Alarm Alarm statistics.
Error Error statistics.
Cpos2/0/0 CT1 2 is up Current physical state of T1 channel 2 on interface CPOS 2/0/0.
Frame-format ESF, clock master,
loopback not set
Information about the physical layer of the T1 channel. The framing
format is set to ESF; master clock (internal clock signal) is used; loopback
is disabled.
T1 framer(2-1-1):
Presents how the T1 channel is multiplexed. 2-1-1 represents in order
VC-3 number, TUG-2 number, and TU-11 number for the T1 channel.
For more information, see Interface Configuration Guide.
display controller cpos t3
Use display controller cpos t3 to display the physical layer configuration of the specified T3 channel on
the specified CPOS interface.