R3102-R3103-HP 6600/HSR6600 Routers Interface Command Reference

57
Current VCs: 0 (0 on main interface)
ATM over E1, Scramble enabled, frame-format crc4-adm
code hdb3, clock slave,Cable-length long, loopback not set
Cable type: 75 ohm non-balanced
Line Alarm: LOS LOF
Line Error: 0 FERR, 0 LCV, 0 CERR, 0 FEBE
Last 0 seconds input rate 0.00 bytes/sec, 0.00 packets/sec
Last 0 seconds output rate 0.00 bytes/sec, 0.00 packets/sec
Input : 0 packets, 0 bytes, 0 buffers
0 errors, 0 crcs, 0 lens, 0 giants,
0 pads, 0 aborts, 0 timeouts
0 overflows, 0 overruns,0 no buffer
Output: 0 packets, 0 bytes, 0 buffers
0 errors, 0 overflows, 0 underruns
# Display brief information about interface ATM 5/1/0.
<Sysname> display interface atm 5/1/0 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
Atm5/1/0 UP UP --
# Display brief information about ATM interfaces in the DOWN state.
<Sysname> display interface atm brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
Atm5/1/0 DOWN Not connected
Table 13 Command output
Field Descri
p
tion
Atm5/1/0 current state
State of the ATM interface:
• DOWN(Administratively)—The ATM interface was shut down with the
shutdown command, and is administratively down.
• DOWN—The ATM interface is physically down (possibly because no
physical link is present or the link has failed).
• UP—The ATM interface is both administratively and physically up.
AAL enabled: AAL5, Maximum
VCs: 128
• ATM adaptation layer (AAL) type: AAL5.
• Maximum number of virtual circuits: 128.
ATM over E1, Scramble
enabled, frame-format crc4-adm
• ATM interface type: ATM over E1.
• Scrambling is enabled.
• Framing format: crc4-adm.
code hdb3, clock
slave,Cable-length long,
loopback not set
• Line coding format: hdb3.
• Clock mode: slave.
• Cable mode: long.
• Loopback is not enabled.