R3102-R3103-HP 6600/HSR6600 Routers Interface Command Reference

86
Examples
# Enable subinterface rate statistics collection on serial interface Serial 1/0/0.
<Sysname> system-view
[Sysname] interface serial 1/0/0
[Sysname-Serial1/0/0] sub-interface rate-statistic
timer hold
Use timer hold to set the polling interval, the interval at which the interface sends keepalive packets.
Use undo timer hold to restore the default.
Syntax
timer hold seconds
undo timer hold
Default
The polling interval is 10 seconds.
Views
Serial interface view
Default command level
2: System level
Parameters
seconds: Interval at which an interface sends keepalive packets, in the range of 0 to 32767 seconds.
Examples
# Set the polling interval to 20 seconds for interface serial 1/0/0.
<Sysname> system-view
[Sysname] interface serial 1/0/0
[Sysname-Serial1/0/0] timer hold 20
virtualbaudrate
Use virtualbaudrate to set a virtual baud rate for the DTE-side interface.
Use undo virtualbaudrate to remove the specified virtual baud rate.
Syntax
virtualbaudrate virtualbaudrate
undo virtualbaudrate
Views
Synchronous serial interface view
Default command level
2: System level