R3102-R3103-HP 6600/HSR6600 Routers Interface Configuration Guide

Ste

Command

Remarks

15. Set the intended bandwidth

for the POS interface.

bandwidth bandwidth-value Optional.

16. Restore the default settings for

the POS interface.

default Optional.

17. Shut down the POS interface.

shutdown

Optional.

By default, a POS interface is up.

When you modify parameters on a

POS interface, execute the

shutdown command, and then the

undo shutdown command to make

your modifications take effect.

NOTE:

If no cable is connected to a physical interface, shut down the interface with the shutdown command to

prevent anomalies caused by interference. Use the shutdown command with caution because once an

interface is shut down, it stops operating.

Enabling sub-interface rate statistics collection for a POS

interface

With sub-interface rate statistics collection enabled for a POS interface, the device refreshes the

sub-interface rate statistics of the POS interface periodically. Use the display command to view the

collected statistics.

To enable sub-interface rate statistics collection for a POS interface:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enter POS interface view.

interface pos interface-number N/A

3. Enable sub-interface rate statistics

collection for the POS interface.

sub-interface rate-statistic

Optional.

Disabled by default.

NOTE:

Use this feature cautiously, because it is system resource demanding.

Configuring the working mode of a POS interface

card

Some POS interface cards support multiple working modes. You can switch their working modes as

needed. For more information about the working modes of interface cards, see Fundamentals

Configuration Guide.