R3102-R3103-HP 6600/HSR6600 Routers IP Multicast Command Reference

227
[Sysname-bgp] ipv4-family multicast
[Sysname-bgp-af-mul] filter-policy 2000 import
import-route (MBGP address family view)
Use import-route to enable route redistribution from a specified routing protocol.
Use undo import-route to disable route redistribution from a routing protocol.
Syntax
import-route protocol [ { process-id | all-processes } [ allow-direct | med med-value | route-policy
route-policy-name ] * ]
undo import-route protocol [ process-id | all-processes ]
Default
MBGP does not redistribute routes from other protocols.
Views
IPv4 MBGP address family view
Default command level
2: System level
Parameters
protocol: Redistributes routes from the routing protocol, which can be direct, isis, nat, ospf, rip, or static.
process-id: Specifies a process ID in the range of 1 to 65535. It is available only when the protocol is isis,
ospf, or rip.
all-processes: Redistributes routes from all the processes of the specified routing protocol. It is available
only when the specified protocol is isis, ospf, or rip.
allow-direct: Redistributes direct routes from the specified routing protocol. This keyword is available only
when the specified routing protocol is OSPF. Without this keyword, BGP does not redistribute direct
routes from OSPF. If you specify the route-policy route-policy-name keyword together with the
allow-direct keyword, make sure that no rule in the routing policy conflicts with any direct route. For
example, do not configure the if-match route-type command for the routing policy to filter OSPF routes.
Otherwise, the allow-direct keyword does not take effect.
med-value: Specifies a MED value for redistributed routes, in the range of 0 to 4294967295. If the
argument is not specified, the cost of a redistributed route is used as its MED in the BGP routing domain.
route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63 characters.
Usage guidelines
The origin attribute of routes redistributed through the import-route command is incomplete.
The undo import-route protocol all-processes command can cancel only the configuration that you make
by using the import-route protocol all-processes command. To cancel the configuration that you make by
using the import-route protocol process-id command, you must use the undo import-route protocol
process-id command.
Examples
# In IPv4 MBGP address family view, enable route redistribution from RIP.
<Sysname> system-view