R3102-R3103-HP 6600/HSR6600 Routers IP Multicast Command Reference

302
Default
MLD fast-leave processing is disabled. That is, the MLD querier sends multicast-address-specific queries
or multicast-address-and-source-specific queries after receiving an MLD done message from a host,
instead of sending a leave notification directly to the upstream.
Views
Interface view
Default command level
2: System level
Parameters
acl6-number: Specifies a basic IPv6 ACL number in the range of 2000 to 2999. The fast-leave
processing function takes effect only for the IPv6 multicast groups that match the permit statement in the
ACL. If you do not specify any IPv6 ACL number, this command takes effect for all IPv6 multicast groups.
Examples
# Enable MLD fast-leave processing on GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet2/1/1
[Sysname-GigabitEthernet2/1/1] mld fast-leave
Related commands
• fast-leave (MLD view)
• mld last-listener-query-interval
mld group-limit
Use mld group-limit to configure the maximum number of IPv6 multicast groups that an interface can
join.
Use undo mld group-limit to restore the default.
Syntax
mld group-limit limit
undo mld group-limit
Default
The maximum number is 1024.
Views
Interface view
Default command level
2: System level
Parameters
limit: Specifies the maximum number of IPv6 multicast groups that an interface can join, in the range of
1 to 1024.