R3102-R3103-HP 6600/HSR6600 Routers IP Multicast Command Reference

29
Usage guidelines
The source-ip source-address option in the command is meaningful only for IGMPv3 snooping. If
IGMPv2 snooping is running, the source-ip source-address option does not take effect although you can
include source-ip source-address in the command.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this command takes effect only if
the interface belongs to the specified VLAN.
In port group view, this command takes effect only on those ports in this port group that belong to the
specified VLAN.
Examples
# Configure GigabitEthernet 2/0/1 in VLAN 2 to be a static member port for the multicast source and
g r o u p (1.1.1.1, 23 2.1.1.1) .
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] igmp-snooping static-group 232.1.1.1 source-ip 1.1.1.1
vlan 2
igmp-snooping static-router-port
Use igmp-snooping static-router-port to configure a port as a static router port.
Use undo igmp-snooping static-router-port to restore the default.
Syntax
igmp-snooping static-router-port vlan vlan-id
undo igmp-snooping static-router-port vlan vlan-id
Default
No ports are static router ports.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default command level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN. The value range for the vlan-id argument is 1 to 4094.
Usage guidelines
For a router that supports both IGMP snooping and IGMP and is installed with the SAP module, this
command takes effect in IGMP snooping-enabled VLANs and VLANs with IGMP-enabled VLAN
interfaces.
This command does not take effect in a sub-VLAN of a multicast VLAN.