R3102-R3103-HP 6600/HSR6600 Routers IP Multicast Command Reference

31
last-member-query-interval (IGMP-snooping view)
Use last-member-query-interval to configure the IGMP last-member query interval globally.
Use undo last-member-query-interval to restore the default.
Syntax
last-member-query-interval interval
undo last-member-query-interval
Default
The default setting is 1 second.
Views
IGMP-snooping view
Default command level
2: System level
Parameters
interval: Sets the IGMP last-member query interval in seconds, in the range of 1 to 5.
Usage guidelines
The IGMP last-member query interval determines the interval for sending IGMP group-specific queries
and the maximum response delay for IGMP group-specific queries.
For a router that supports both IGMP snooping and IGMP and is installed with the SAP module, this
command takes effects in IGMP snooping-enabled VLANs but not in VLANs with IGMP-enabled VLAN
interfaces.
Examples
# Set the IGMP last-member query interval to 3 seconds globally.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] last-member-query-interval 3
Related commands
igmp-snooping last-member-query-interval
max-response-time (IGMP-snooping view)
Use max-response-time to set the global maximum response delay for IGMP general queries.
Use undo max-response-time to restore the default.
Syntax
max-response-time interval
undo max-response-time
Default
The default setting is 10 seconds.