R3102-R3103-HP 6600/HSR6600 Routers IP Multicast Command Reference

424
[Sysname-bgp-af-ipv6-mul] preference 20 20 200
reflect between-clients (IPv6 MBGP address family view)
Use reflect between-clients to enable route reflection between clients.
Use undo reflect between-clients to disable this function.
Syntax
reflect between-clients
undo reflect between-clients
Default
Route reflection between clients is enabled.
Views
IPv6 MBGP address family view
Default command level
2: System level
Usage guidelines
After a route reflector is configured, it reflects the routes of a client to the other clients. If the clients of a
route reflector are fully meshed, you need to disable route reflection between clients to reduce routing
costs.
Examples
# Enable route reflection between clients
<Sysname> system-view
[Sysname]bgp 100
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] reflect between-clients
Related commands
• peer reflect-client
• reflector cluster-id
reflector cluster-id (IPv6 MBGP address family view)
Use reflector cluster-id to configure the cluster ID of the route reflector.
Use undo reflector cluster-id to remove the configured cluster ID.
Syntax
reflector cluster-id cluster-id
undo reflector cluster-id
Default
Each route reflector uses its router ID as the cluster ID.
Views
IPv6 MBGP address family view