R3102-R3103-HP 6600/HSR6600 Routers IP Multicast Command Reference

35
Default
The aging timer of dynamic router ports is 105 seconds.
Views
IGMP-snooping view
Default command level
2: System level
Parameters
interval: Specifies an aging timer in seconds for the dynamic router ports, in the range of 1 to 1000.
Usage guidelines
For a router that supports both IGMP snooping and IGMP and is installed with the SAP module, this
command takes effect in IGMP snooping-enabled VLANs but not in VLANs with IGMP-enabled VLAN
interfaces.
Examples
# Set the aging timer for the dynamic router ports to 100 seconds globally.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] router-aging-time 100
Related commands
igmp-snooping router-aging-time
source-deny (IGMP-snooping view)
Use source-deny to enable multicast source port filtering so that all multicast data packets are blocked.
Use undo source-deny to disable multicast source port filtering.
Syntax
source-deny port interface-list
undo source-deny port interface-list
Default
Multicast source port filtering is not enabled.
Views
IGMP-snooping view
Default command level
2: System level
Parameters
interface-list: Specifies one or multiple ports. You can provide up to ten port lists. For each list, you can
specify an individual port in the form of interface-type interface-number, or a port range in the form of
interface-type start-interface-number to interface-type end-interface-number, where the end interface
number must be greater than the start interface number.