R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Command Reference

149
Default
The TPID value in both SVLAN and CVLAN tags is 0x8100, and the TPID used by a port in the SVLAN
or CVLAN tag equals the global SVLAN or CVLAN tag TPID (if the device supports global TPID
configuration) or 0x8100 (if the device does not support global TPID configuration).
Views
System view, Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default command level
2: System level
Parameters
customer-tag: Specifies the TPID value in the CVLAN tag.
service-tag: Specifies the TPID value in the SVLAN tag.
hex-value: Sets a hexadecimal TPID value in the range of 0x0001 to 0xFFFF, excluding the common
protocol type values listed in Table 35.
Table 35 Common prot
ocol type values
Protocol t
yp
e Value
ARP 0x0806
PUP 0x0200
RARP 0x8035
IP 0x0800
IPv6 0x86DD
PPPoE 0x8863/0x8864
MPLS 0x8847/0x8848
IPX/SPX 0x8137
IS-IS 0x8000
LACP 0x8809
802.1X 0x888E
Cluster 0x88A7
Reserved 0xFFFD/0xFFFE/0xFFFF
Usage guidelines
Configured in Layer 2 Ethernet interface view, the command takes effect on the interface only.
Configured in Layer 2 aggregate interface view, the command takes effect on the Layer 2 aggregate
interface and all the member ports in the aggregation group.
Configured in port group view, the command takes effect on all ports in the port group.
Examples
# Set the global TPID value in CVLAN tags to 0x8200.
<Sysname> system-view
[Sysname] qinq ethernet-type customer-tag 8200