R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Command Reference

153
Syntax
vlan-type dot1q vid vlan-list
undo vlan-type dot1q vid vlan-list
Views
Layer 3 Ethernet subinterface view, Layer 3 aggregate subinterface view
Default command level
2: System level
Parameters
vlan-list: Specifies a list of outmost VLAN IDs in the format of vlan-list = { vlan-id1 [ to vlan-id2 ] }&<1-10>,
where the vlan-id argument is in the range of 1 to 4094, and &<1-10> indicates that you can specify up
to 10 VLAN ID ranges.
Usage guidelines
You cannot configure multiple subinterfaces under an Ethernet interface to terminate VLAN-tagged
packets from the same VLAN. The VLAN ID ranges specified by the vlan-list argument for different
subinterfaces cannot overlap with each other.
After you use the undo vlan-type dot1q vid command to disable Dot1q termination on the subinterface,
the subinterface will restart, and the ARP table entry corresponding to the subinterface will be removed.
Examples
# Configure GigabitEthernet 4/0/1.1 to terminate VLAN-tagged packets with the outermost VLAN IDs in
the range of 2 to 100.
<Sysname> system-view
[Sysname] interface GigabitEthernet 4/0/1.1
[Sysname-GigabitEthernet4/0/1.1] vlan-type dot1q vid 2 to 100
vlan-type dot1q vid second-dot1q
Use vlan-type dot1q vid second-dot1q to enable QinQ termination, and specify the Layer 2 and Layer
1 VLAN IDs of VLAN-tagged packets that can be terminated by the current subinterface.
Use undo vlan-type dot1q vid second-dot1q to restore the default.
Syntax
vlan-type dot1q vid vlan-id second-dot1q { vlan-list | any }
undo vlan-type dot1q vid vlan-id second-dot1q { vlan-list | any }
Views
Layer 3 Ethernet subinterface view, Layer 3 aggregate subinterface view
Default command level
2: System level
Parameters
vlan-id: Specifies a Layer 1 VLAN ID in the range of 1 to 4094.
any: Specifies all values between 1 and 4094 other than the Layer 2 VLAN IDs assigned to other
subinterfaces that have the same Layer 1 VLAN ID as the current subinterface. For example, assume that
the current subinterface is configured to terminate VLAN-tagged packets with Layer 1 VLAN ID x, and