R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Command Reference

58
vlan vlan-list: Specifies a VLAN list in the format of vlan-list = { vlan-id [ to vlan-id ] }&<1-10>, where the
vlan-id argument represents the VLAN ID in the range of 1 to 4094, and &<1-10> indicates that you can
specify up to 10 VLAN IDs or VLAN ID ranges.
Usage guidelines
If you specify no VLAN in the undo instance command, all VLANs mapped to the specified MSTI will be
remapped to the CIST.
You cannot map the same VLAN to different MSTIs. If you map a VLAN that has been mapped to an MSTI
to a new MSTI, the old mapping will be automatically removed.
After configuring this command, run the active region-configuration command to activate the
VLAN-to-instance mapping.
Examples
# Map VLAN 2 to MSTI 1.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] instance 1 vlan 2
Related commands
• active region-configuration
• check region-configuration
• display stp region-configuration
region-name
Use region-name to configure the MST region name.
Use undo region-name to restore the default MST region name.
Syntax
region-name name
undo region-name
Default
The MST region name of a device is its MAC address.
Views
MST region view
Default command level
2: System level
Parameters
name: Specifies the MST region name, a string of 1 to 32 characters.
Usage guidelines
The MST region name, the VLAN-to-instance mapping table, and the MSTP revision level of a device
determine the device's MST region.
After configuring this command, run the active region-configuration command to activate the configured
MST region name.