R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Configuration Guide

97
Ste
p
Command Remarks
3. Configure the link type of
the ports as trunk.
port link-type trunk By default, all ports are access ports.
4. Assign the trunk ports to
the specified VLANs.
port trunk permit vlan
{ vlan-list | all }
By default, a trunk port carries only VLAN 1.
5. Configure the PVID of the
trunk ports.
port trunk pvid vlan vlan-id
Optional.
By default, the PVID is VLAN 1.
To change the link type of a port from trunk to hybrid or from hybrid to trunk, you must set the link type
to access first.
After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to configure
the trunk port to allow packets from the PVID to pass through.
Assigning a hybrid port to a VLAN
A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view. Before assigning
a hybrid port to a VLAN, create the VLAN first.
To assign a hybrid port to one or multiple VLANs:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view or port
group view.
• Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
• Enter Layer 2
aggregation interface
view:
interface
bridge-aggregation
interface-number
• Enter port group view:
port-group manual
port-group-name
Use one of the commands.
• The configuration made in Ethernet
interface view applies only to the port.
• The configuration made in port group
view applies to all ports in the port group.
• The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.
3. Configure the link type of
the ports as hybrid.
port link-type hybrid By default, all ports are access ports.
4. Assign the hybrid ports to
the specified VLANs.
port hybrid vlan vlan-list
{ tagged | untagged }
By default, a hybrid port allows only packets
of VLAN 1 to pass through untagged.
5. Configure the PVID of the
hybrid ports.
port hybrid pvid vlan
vlan-id
Optional.
By default, the PVID is VLAN 1.
To change the link type of a port from trunk to hybrid or from hybrid to trunk, you must set the link type
to access first.